thedy

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: troubleshooting ht16k33 #2517
    thedy
    Participant

    i added the following line in the original MeinEnigma Sked and downloaded it to the Arduino. After this, it worked as it has to. Without replacing the HT16K33

    on line 2012 after the ‚void checkSwitchPos()
    i added the following:

    HT.displayOn();

    Perhaps someone else can verify it, if it runs there too ?

    Best Regards and good luck with upgrading the Arduino 😉

    in reply to: troubleshooting ht16k33 #2474
    thedy
    Participant

    Hello again,

    everything works fine. When i push L for the light test, all is dark except the 4 dots on the alpha displays. When i push C the 2nd dot blinks in a 1 second rhythm. In UKW mode, the voice say the correct letter that i push. In run mode i can enter text and can see the encryption in the terminal window on the PC, but not on the LED’s nor on the alpha display.

    Log:

    MeinEnigma Version: 1.10d
    Checksum seems OK, (24B4) keeping the values
    IC detected
    Looking for soundboard
    Found a soundboard, activating it
    Time is: 2024-03-14 19:24:47
    Preparing plugboard
    All LEDs on
    All LEDs off

    Machine mode: model
    Version: 1.10d
    Preset: 0

    Odometer: 98
    Morse code: OFF
    TTS: ON
    Serial number: 156

    Model: M3 (Enigma M3, German Navy (Kriegsmarine))
    Reflector: UKWB
    Rotors: I – II – III
    Ringstellung: – A A A
    Plugboard: physical – empty
    CurrentWalze: – A A G
    Time is: 2024-03-14 19:24:52

    Ready
    Time is :19:24
    Time is :19:24
    All lights on
    All lights off
    All lights on
    All lights off
    sound OFF
    sound ON
    morsecode ON
    morsecode OFF

    in reply to: troubleshooting ht16k33 #2468
    thedy
    Participant

    i just assembled the tit #156 and now have exactly the same issues with the LED’s and alphanumeric displays. When i push one of the 4 button by the wheels to recall a preset, most time it shows PR 1 (2, 3 or 4), but nothing else. Everything else seems working well.

    I also checked everything, shortcuts, wrong direction of LED’s bat soldering points ….

    Any suggestions ?

    Best Regards from Swizerland
    Thedy

Viewing 3 posts - 1 through 3 (of 3 total)

Archives