Glenn McIntosh

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: troubleshooting ht16k33 #2443
    Glenn McIntosh
    Participant

    I replaced the ht16k33 on the assumption that I’d somehow killed the row drivers, and it is all working now!

    The keyboard is a bit of a frankenstein’s monster after I used a breakout board version of the ht16k33, but that’s all hiding underneath 🙂
    https://archive.meme.au/meinenigma-2d38250c/keyboard.jpg

    Overall, the instructions for construction were comprehensive and the only minor issues I had were the battery connector terminals being a bit loose for the wire gauge, and one hole on the board (for the Arduino socket) was blocked and had to be drilled out.

    Thanks for a great kit.

    in reply to: troubleshooting ht16k33 #2440
    Glenn McIntosh
    Participant

    The startup seems fine (I’m guessing the ‘IC detected’ line is for the ht16k33, I have the plugboard disconnected for now). Power and clk/data are working, I’ve re-checked all the LEDs, will continue to investigate. I’ll figure it out, thanks for the response.

    MeinEnigma Version: 1.10d
    Checksum seems OK, (E9AA) keeping the values
    IC detected
    Looking for soundboard
    Found a soundboard, activating it
    Time is: 200-01-03 19:38:18
    No plugboard found
    All LEDs on
    All LEDs off

    Machine mode: run
    Version: 1.10d
    Preset: 0

    Odometer: 561
    Morse code: OFF
    TTS: ON
    Serial number: 157

    Model: M3 (Enigma M3, German Navy (Kriegsmarine))
    Reflector: UKWC
    Rotors: I – II – III
    Ringstellung: – A A A
    Plugboard: virtual –
    CurrentWalze: – B Q M
    Time is: 200-01-03 19:38:23

    Ready

Viewing 2 posts - 1 through 2 (of 2 total)

Archives