Reply To: Kit #55 not yet working


A low resistance (<2 ohm) is normal and not a problem along a trace like that. Did just check and and on my working meinEnigma it is 1.5ohm.
For the software to find the chip it need only 4 wires to work, power, ground, A5(SCL) & A4(SDA). Now if any of those wires are shorted between each other it's of course a problem also so please verify that it's not unexpected shorts.
If you have a oscilloscope you can look at the signal on A4/A5.
I would have no problem taking a look at it if it wasn't for the shipping cost.